Honeywell 5005 Manual Del Usario página 2

SETUP
STEP 1. OPEN SAFE WITH OVERRIDE KEY
1. Remove override key cover with small screwdriver.
2. Insert override key and turn left to unlock safe.
3. Turn knob to right and open safe door.
STEP 2. INSTALL BATTERIES
1. Remove battery compartment (A) cover on inside
door. Insert 4 "AA" batteries (included). Ensure the
batteries are installed in the correct direction, with
regard to polarity (+ and -) See diagram.
2. Replace the battery cover.
3. Do not close door before testing digital lock.
STEP 3. TEST DIGITAL LOCK
1. With door open, turn knob left to put locking door bolts in lock position.
2. Remove override key and store in a secure place.
NEVER STORE KEYS INSIDE SAFE!
3. Enter the preset pass code: "1"-"5"–"9"-"E".
4. Turn knob to right within 5 seconds.
5. Lock bolts should recede into the unlocked position.
STEP 4. PROGRAM A NEW PASSCODE
1. With door open, press reset button (C) inside
door.
2. Yellow light is on, enter new pass code in 30
seconds.
3. Enter new code (3 to 8 digits) followed by "E".
Press "C" to clear entry if wrong digit is entered.
4. Safe will beep and yellow light will turn off.
NOTE: The factory pre-set code will not work after a new pass code is programmed.
OPERATION
TO OPEN THE SAFE
1. To unlock and open safe, enter the pass code followed by "E".
2. Green light will turn on.
3. You will have 5 seconds to turn door entry knob to the right and
open door.
TO CLOSE THE SAFE
1. Close the door and hold it in the closed position.
2. Turn door entry knob to left to engage the lock bolts and lock safe.
2
SECURE LOCKOUT PERIODS
If a wrong code is entered three times in a row, the digital keypad will begin a five-
minute secure lockout period. During this secure lockout period the keypad will
become disabled. Once the lockout period has expired, the safe can be unlocked
using the correct passcode. You may use the override key to open safe, but keypad
will complete the full lockout period.
OVERRIDE ACCESS KEY
If the pass code is unavailable or your keypad fails due to dead batteries or other
malfunction, you can open the safe using the override access key (see STEP 1. in the
SETUP section).
REPLACING BATTERIES
Note: The pass code will not be erased if the batteries become weak or are removed.
Weak or dead batteries should be replaced immediately and all 4 batteries should be
changed. To replace the batteries please follow the instructions in STEP 2. in the
"SETUP" section. Remember to always remove batteries from safe if not using for an
extended period of time. If your batteries are completely dead and you cannot open
the safe by using the digital keypad, use the override access key to open safe and
access the battery compartment.
NOTE: It is NOT RECOMMENDED to use Non-alkaline or rechargeable batteries.
IF YOU FORGET THE PASSCODE
1. Use the override access key to open safe.
2. With door open, press red reset button (C) inside
door.
3. Yellow light is on; enter new pass code in 30
seconds.
4. Enter pass code (3 to 8 digits) followed by "C"
5. Safe will beep and yellow light will turn off.
3