Restore Default Settings - HyperIce Normatec 2.0 Pro Instrucciones De Operación

PATENTED NORMATEC PULSE MASSAGE PATTERN
Before the patented NORMATEC PULSE massage pattern begins, you will experience a pre-inflate cycle, during
which the connected attachments are molded to your exact body shape. Once the pre-inflate cycle is complete, the
patented NORMATEC PULSE massage pattern will begin by compressing your feet, hands, or upper quad (depending
on which attachment you are using). Similar to the kneading and stroking performed during a massage, each zone of the
attachments will first compress in a pulsing manner and then release as the compression pattern works its way up your
limb. When the top zone completes its massage, there will be a brief rest period and then the cycle will begin again. This
will repeat until the session time runs out.
When the session is resumed after a pause, the system will perform a pre-inflate cycle before continuing.
SEQUENTIAL MASSAGE PATTERN
The SEQUENTIAL massage pattern begins by compressing your feet, hands, or upper quad (depending on which
attachment you are using). Each zone of the attachments will compress and hold pressure. This will repeat for each zone
of the attachments as the compression pattern works its way up your limb.
ADJUST THE NUMBER OF ZONES
The number of attachment zones that are enabled can be changed between one and five zones. Zones can be disabled
from the top to the bottom of the attachment, one zone at a time. Zone adjustments remain after you turn off the control
unit. Adjust the number of zones by tapping on the menu icon in the upper left and selecting the advanced options button.
On the next menu, select the number of zones option. The number of zones screen will open. Use the and buttons
to increase or decrease the number of enabled zones. At least one zone must be enabled. Enabled zones are solid blue,
disabled zones are solid gray. This option can only be adjusted before a session starts.
ADJUST DISPLAY BRIGHTNESS
Adjust the display brightness by tapping on the menu icon in the upper left and selecting the control unit preferences
button. On the next menu, select the display brightness option. The display brightness screen will open. Use the and
buttons to adjust the display brightness between level 1 and 10. Brightness level 1 is the darkest and level 10 is the
brightest.

RESTORE DEFAULT SETTINGS

Reset the control unit to factory settings by tapping on the menu icon in the upper left and selecting the control unit
preferences button. On the next menu, select the factory reset option. The factory reset screen will open. Tap the reset
control unit button, and then the Yes, reset control unit button to confirm the reset. This option can only be adjusted
before a session starts.
12