Ribimex Ribitech PRBAT20/CC4 Manual De Instrucciones página 17

(B) Additional safety rules for impact wrench
a) Recommendation for the operator to wear hearing protection. Wear ear protectors. Exposure to noise
can cause hearing loss.
b) Use auxiliary handles (if supplied with the tool). Loss of control can cause injuries.
c) Hold power tool by insulated gripping surfaces when performing an operation where the accessory
or the screw may contact hidden wiring or the tool's own power cord. Cutting accessory contacting a
"live" wire may make exposed metal parts of the power tool "live" and shock the operator.
d) Hold the power tool with a firm grip with both hands (if possible) and keep a good balance.
The tool is best guided with both hands. If bit gets locked, a strong torque reaction may occur when screwing
in or loosening screws.
e) Use appropriate detectors to determine if utility lines are hidden in the work area or call the local
utility company for assistance. Contact with electric lines can lead to fire and electric shock. Damaging a
gas line can lead to explosion. Penetrating a water line causes property damage or electric shock.
f) Secure the workpiece. Never hold the workpiece in your hand or across your legs or against your
body. A workpiece clamped with clamping devices or in a vice is held more secure than by hand. An unstable
workpiece can cause loss of control of the tool and/or injury.
g) Position yourself so as to avoid being caught between the tool or auxiliary handle (if supplied) or bit and
workpiece. Should the bit become jammed in the workpiece, the reaction torque of the tool could crush
your body.
h) Do not use dull or damaged bits and/or accessories. Dull or damaged bits/accessories have a greater
tendency to get jammed in the workpiece, or to break, or to be ejected.
i) When installing a bit/accessory in the chuck, insert the bit/accessory well inside the chuck. If the bit /
accessory is not inserted properly, the grip of the chuck over the bit / accessory is greatly reduced likely to
increase the risk of loss of control. After inserting the bit, pull on it, so as to ensure that it is properly locked.
j) Never grasp the tool (the chuck or the accessory) while in motion and never place your hands too close to
the spinning chuck or accessory. Injury hazard.
k) Always wait until the chuck and accessory have come to a complete stop before placing it down.
The accessory can jam and lead to loss of control over the power tool.
l) Some materials may contain chemicals that can be toxic. Avoid inhalation of dust and any contact
with the skin.
Page 17 / 57