Troubleshooting; Before Calling For Service - Kenmore 580.73069 Manual Del Propietário

Ocultar thumbs Ver también para 580.73069:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BEFORE CALLING FOR SERVICE
Check
the following
list to be sure a service
call is really necessary.
A quick
reference
to this manual
may
help you avoid an unneeded
service
call.
THE AIR CONDITIONER
WILL NOT OPERATE
Check
if...
Wall plug disconnected.
House fuse blown or circuit breaker tripped.
Power is OFF.
Unit was turned off and then on too quickly,
TEMP Control set warmer than room temperature.
Then...
Push plug firmIy into wall outlet.
Replace fuse with time delay type or reset circuit breaker.
Push the power button.
Set unit off and wait 3 minutes before restarting.
Set TEMP Control to a lower temperature.
AIR FROM
UNIT
DOES
NOT
FEEL
COLD
ENOUGH.
Check
if...
Then...
FAN SPEED set at LOW.
Push FAN SPEED button to set at HIGH.
TEMP Control set too warm.
Set TEMP Control to a lower temperature.
Room temperature below 70°F (21°C).
Cooling may not occur until room temperature rises above 70°F (21°C).
Temperature sensing tube touching evaporator coil,
Straighten tube away from evaporator coil
located behind front griIle.
THE AIR CONDITIONER
COOLING,
BUT ROOM tS TOO
WARM-ICE
FORMING ON COOLING COIL BEHIND FRONT GRILLE.
Check
if...
Then...
Outdoor temperature below 70°F (21°C).
To defrost the coil, set the MODE to FAN, Fan speed to High.
Air filter may be dirty.
Clean air filter. Refer to Maintenance section of owner's manual
TEMP Control set too low.
To defrostthe coil,set the MODE to Cool, Fan speed to high, and the
Temp control to a higher temperature.
THE AIR CONDITIONERCOOLING, BUTROOM IS TOO WARM
Check
if...
Then...
Dirty air filter- air restricted.
Clean air filter. Refer to Maintenance section of owner's manual
TEMP Control set too warm.
Set TEMP Control to a lower temperature.
Front of unit is blocked by drapes, blinds, furniture, etc.
Clear blockage in front of unit.
Air distribution is restricted.
Doors, windows, registers, etc. open. Cold air escapes.
Close doors, windows, registers, etc.
Unit recently turned on in hot room.
Allow additional t ime to removestoredheatfrom wails,ceiling,floor,andfurniture.
THE AIR
CONDITIONER
TURNS
ON AND
OFF
RAPIDLY.
Check
if...
Then...
I Outside temperature is extremely hot.
I Set FAN SPEED on LOW to minimize the cooling load.
I
NOISE
WHEN
UNIT
IS COOLING.
Check
if...
Then...
Sound of fan hittingwater- from the moisture removal system. This is normal when humidity is high. Close doors, windows, and registers.
Window vibration - poor installation.
Refer to nsta at on nstruct ons or check w th nsta er.
WATER
DRIPPING
INSIDE
ROOM
WHEN
UNIT
IS COOLING.
Check
if...
Then...
The air conditioner is improperly installed.
TiItinstallationair
conditionerinstructionsSlightiYor
tOcheckthe
outsidewith
instaIIer.t°
allow water drainage. Refer to
WATER
DRIPPING
OUTSIDE
WHEN
UNIT
IS COOLING.
Check
if...
Then...
The unit is removing targe quantities of moisture
This is normal during excessively humid days.
from humid room.
-14-

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido