Power Supply; Remote Controller - Beamz IP65 Outdoor laser Manual De Instrucciones

POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
INSTALLATION
Follow the installation steps below:
1. Install the grounding adapter to the laser with the screw and tighten.
2. Insert the grounding adapter into the ground.
3. Adjust the angle and then fix the screw.
4. Connect de power.

REMOTE CONTROLLER

1. ON/OFF
2. Strobe accelerated
3. Motor accelerated
4. Strobe decelerated
5. Timer, shut down automatically after 2hours
6. Timer, shut down automatically after 1hours
7. Timer, shut down automatically after 4hours
8. Timer, shut down automatically after 5hours
9. Timer, shut down automatically after 6hours
10. Timer, shut down automatically after 3hours
11. Motor decelerated
12. Colour Switch (single red, single green, red& green)
Note: Remote controller receiving range 5-10 meter
4
CAUTION: Please consider the respective national norms during the
installation!
CAUTION: When installing the device, make sure there is no highly in
inflammable material (decoration articles, etc.) in between a
distance of min 0.5 meter.