Polk surroundbar 6500BT Manual De Instrucciones página 10

How To SET uP A REMoTE CoNTRol
FoR youR SuRRouNDBAR
SMARTBAR PRogRAMMINg NoTE:
™
For your SurroundBar to respond to your remote control, you
MUST FIRST program the bar to respond to your television's
original IR (Infra-Red) remote. An RF (Radio Frequency)
remote will not work. Other remotes (cable, satellite) will
work only after you have programmed the bar to respond
to the TV's IR remote.
Programming Instructions: Your SurroundBar is currently
programmed to respond to the remote control that is included
with the product. However, we strongly recommend programming
the SurroundBar to also respond to your existing remote control
using the steps illustrated below. This will enable you to operate
all of your components using a single remote control. while
programming the SurroundBar, ignore anything that
may be displayed on the Tv screen.
Example: To teach your bar the "Volume Up"
command of your remote control:
1
The SurroundBar is turned on and the LED is solid green.
And you have sound coming from the bar.
2 Press and hold "LEARN" for 2 seconds, or until LED
blinks orange, then release the "LEARN" button.
LEARN SOURCE
3
Press and release Volume Up "
LED turns solid orange.
MUTE
LED
Solid orange
4
Hold TV remote 1' - 2' from SurroundBar.
1' - 2'
LED
Blinks orange
."
Customer Service Hours of Operation: Monday-Friday, 9
5
Tap "Volume Up" button on your TV's remote control
4 - 8 times, once per second. Tap, do not hold.
LED
LED blinks with
each button press
6
When the LED blinks green quickly for 3 seconds,
the command has been learned. The LED will
become solid green.
LED
LED blinks green,
then turns solid green
Verify command works.
Repeat steps 1-6 to program "volume Down" (
Mute and Power buttons (
Note: If your bar fails to learn certain IR remote codes, the power
LED will blink red. Try erasing any previously programmed codes
(see below) and carefully repeat steps 1-6 above.
Code Erasing Procedure: If you have programmed your
SurroundBar to respond to a remote control and you no longer
want it to do so, erase the codes by pressing the LEARN key for
about two seconds while the unit is in standby mode (power LED
is red). You'll know that previously learned codes have been
successfully erased when the power LED blinks orange twice.
Note: This procedure removes All of your bar's remote control
programming. If you only need to change the programming for
some of the bar buttons, follow the six steps in the sequence
previously described to redo any previous programming.
The SurroundBar will continue to respond to the provided credit
card remote control.
SuB voluME CoNTRol oN THE BAR
While unit is on and LED is solid green.
1. Tap lEARN once, LED (
2. To adjust sub volume, tap up (
3. To return to master volume, tap lEARN again,
LED ( ) turns green.
NoTE: Bass can also be adjusted with included remote control.
VOL
VOL
), Source,
).
) turns orange.
) or down (
).
-5:30 polkcs@polkaudio.com
am pm est
9