Fagor VTR-10 Manual De Instrucciones página 12

or lack of experience and knowledge,
unless they have been given supervi-
sion or instruction concerning use of the
appliance by a person responsible for
their safety.
• Children should be supervised to ensure
that they do not play with the appliance.
3. ASSEMBLY INSTRUCTIONS
Before assembling the fan, take the
different parts out of the packaging and
check that the supply cable is not damaged
and that the appliance has not received any
knocks during transport. If the appliance is
damaged, do not switch it on.
1A. ASSEMBLING THE BASE
1A1.- MODELS: VTR-10 / VTR-10M /
VTR-12 / VTR-12M / VTR-16 / VTR-16M
1. Thread the cable through the hole in the
base.
2. Mount the motor support on the base as
shown in the figure.
1A2.- MODEL: VTR-16P
1. Remove the nut screwed onto the shaft.
2. Mount the shaft on the base support and
fix it in place with the nut.
3. Loosen the screw and pull the inner
shaft up to the desired height. Then
tighten the screw again. Place the motor
support on the base and fasten it in
place with the fixing screw.
1A3.- MODEL: VTR-15P
1. Remove the nut screwed onto the shaft
and fit the legs to the fan as shown in
the picture.
2. Place the shaft so that the holes for
fitting the screws coincide. Then screw
in and tighten the screws. Insert the
embellisher first, followed by the nut.
3. Pull the inner shaft upwards to the
desired height and tighten the nut. Fit
the motor support to the base and
fasten it in place with the fixing screw.
1B. ASSEMBLING THE FAN
1B1.- MODELS: VTR-10 / VTR-10M /
VTR-12 / VTR-12M / VTR-16 / VTR-16M /
VTR-16P
1. Unscrew the nuts on the motor shaft
(anticlockwise) and the motor casing
(clockwise) respectively.
2. Mount the rear protection grille on the
motor casing and fix it in place with the
fastening nut.
3. Insert the blades on the motor shaft,
fastening them in place with the blade
fixing nut. Turn the blades manually to
ensure they spin freely. If they do not
turn freely go back to point 2 and mount
them again.
4. Mount the front protection grille and
gently press it until it fits into the plastic
ring.
5. Close the safety clip and tighten the
screw.
1B2.- MODEL: VTR-15P
1. Unscrew the nut on the motor casing.
2. Mount the decorative ring on the motor
support and then fit the rear protection
grille onto the motor support, fixing it in
place with the nut.
3. Insert the blades on the motor shaft,
fastening them in place with the blade
fixing nut.
Turn the blades manually to ensure they
spin freely. If they do not turn freely go
back to point 2 and mount them again.
4. Fit the plastic ring to the front protection
grille, then fit the front protection grille
onto the rear protection grille and tighten
the fixing screw.
4. OPERATING INSTRUCTIONS
• Before using the fan, place it on a stable,
flat surface.
• Press the "0" button to ensure the fan is
in stop position, and plug it in.
10