Setting The Clock - Ninja COFFEE BAR CF097C Serie Manual Del Propietário

Setting the Clock & Delay Brew
Fig. 1
Fig. 2
Fig. 3

SETTING THE CLOCK

1
Plug the power cord into an electrical outlet. The clock
will flash on the control panel to indicate that the time
has not been set. (Fig. 1)
2 Press the H (hour) or M (minute) button until you reach
the current time. The AM or PM indicator will illuminate
on the left side of the display as you are setting the
time. (Fig. 2)
3
After 5 seconds, the clock will stop flashing and the
clock will be set.
NOTE: If the clock stops flashing and does not display
the correct time of day, pressing the H (hour) or M
(minute) button at any time will cause the clock to flash
again. You can now reprogram the correct time of day
by following the steps above.
NOTE: If you unplug the brewer or in the event of an
extended power loss, you will need to reset the clock
the next time the brewer is plugged in.
SETTING THE DELAY BREW TIME
NOTE: The Ninja Coffee Bar
for the Delay Brew function to work. Do not power off
after setting Delay Brew.
1
Turn the unit on by pressing the Power button located
under the clock.
NOTE: The clock will remain on even if the unit is
turned off. Ensure the unit is powered on before
setting Delay Brew.
2
Press PROG. The PROG button will illuminate and the
clock will begin to flash "12:00" or the last delay brew
time that was set. (Fig. 3)
13
1-877-646-5288
System must remain on
™
CLASSIC
CLASSIQUE
OVER ICE / SUR GLACE
118 ml
236 ml
Fig. 4
3 While the clock is flashing, press the H (hour) or M
(minute) button to set the time that you would like
the delay brew to begin. The AM or PM indicator will
illuminate on the left side of the display as you are
setting the desired time.
4
Once the proper time has been set, select the size of
the vessel that you would like to brew into.
5
Select the Brew Type that you desire from the 5 flashing
buttons. The selected brew type will be illuminated.
(Fig. 4)
6
Once the time, brew size, and brew type have been
set, allow the PROG button to stop flashing, or press
the PROG button to activate. When the delay brew
is activated, the PROG button will illuminate and an
audible signal will play to verify the delay brew is set.
NOTE: To deactivate the delay brew cycle, press the
PROG button once more and the light will turn off. Any
change to the selected brew size or starting any other
brew will cancel the programmed delay brew.
7
Place the appropriate-sized vessel under brew basket.
IMPORTANT: Make sure the Drip Stop is in the open
position.
Go to ninjakitchen.com for more
information and how-to videos.
RICH
RICHE
4 oz
8 oz