HQ-Power VDL20ST2 Manual Del Usuario página 4

Risk of electroshock when opening the cover. Touching live
wires can cause life-threatening electroshocks. Do not
disassemble or open the housing yourself. Have the device
repaired by qualified personnel.
Be very careful during the installation: touching live wires can
cause life-threatening electroshocks.
DO NOT disassemble or open the cover under any circumstances.
Touching live wires can cause life-threatening electroshocks.
Do not crimp the power cord and protect it against damage.
Warning! If the power cord is damaged, it must be replaced by
the manufacturer, its service agent, or similarly qualified persons
in order to avoid any hazard.
Always disconnect mains power when the device is not in use or
when servicing or maintenance activities are performed. Handle
the power cord by the plug only.
There are no user-serviceable parts inside the device. Refer to an
authorized dealer for service and/or spare parts.
Do not stare directly at the light source, as this may cause
 epileptic seizure in sensitive people
 temporarily loss of sight (flash blindness)
 permanent (irreversible) eye damage.
Caution: Device heats up during use. Never cover the device and
keep the ventilation slots free from dust and obstructions at all
times.
The housing might heat up during usage. Keep minimum
distances around the device for sufficient ventilation. Place the
device on a flat, heat resistant surface. Do not place the device on
carpets, fabrics...
Do not use the device when damage to housing or cables is
noticed. Do not attempt to service the device yourself but contact
an authorised dealer.
 This stroboscope should only be used indoors with an alternating
current of max. 230 V~, 50 Hz.
 Select a location where the device is protected against extreme heat, dust
and moisture. Respect a minimum distance of 0.5 m between the device's
light output and any illuminated surface.
 Use the original packaging if the device is to be transported.
V. 03 – 03/09/2015
VDL20ST2
4 ©Velleman nv