Montarbo M11A Manual De Instrucciones página 9

M11A
self - powered stage monitor
Control and connection panel
3
1 IN: balanced input, fitted with a Neutrik Combo
which accepts both 3 pin XLR and jack plugs.
☛ See 'connectors' at page 25.
2 OUT: balanced output, (in parallel with the input), using a 3 pin
XLR connector. It allows for easy parallel connection of other
M11A.
☛ See 'connectors' and 'connection example' at pages
25 and 26.
3 LEVEL: it is the master volume control. It adjusts the input level
of the built-in power amplifier to adapt it to the output level
of the mixer.
Note: if you are using a Montarbo mixer (or any mixer
having an output level of 0dB), for optimum performance
it is advisable to set the LEVEL control fully clockwise (at
the maximum setting).
The trademark Neutrik Combo is property of Neutrik
®
1 2
connector
®
4
POWER /0 - I: Mains power on/off switch.
5
Mains power cord socket (with built-in fuse).
Use only the factory supplied mains cable or a suitable cable
with a ground connection and marked with the safety
approvals valid in the country of use.
When installing make sure that it is easy to get to this
connector and to the mains plug.
4
5
FUSE REPLACEMENT
Service fuse
Spare fuse
ENGLISH
9