Descargar Imprimir esta página

WMF COUP Instrucciones De Uso página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
Crushing ice cubes
Add a maximum of 6 ice cubes and close the glass jug (3) with the lid (2) and
closing cap (1). Move the selector switch (8) to the Pulse level for a few seconds
and then back to the Off position
. As soon as the ice cubes have fallen back to
the bottom of the glass jug (8), you can switch to the Pulse level again for a few
seconds. Repeat the process until the crushed ice has the desired consistency.
Note: For a more homogeneous result, add some water to the ice cubes.
Glass jug
Lid with closing cap
The closing cap (1) in the lid (2) can be removed and used as a measure (10 / 20 /
30 ml) by turning it anti-clockwise.
The lid (2) reliably and tightly seals the glass jug. The lid (2) has a tab which you
can use to make it easier to remove the lid.
You can add more ingredients through the opening, even during operation.
Disassembling the glass jug
The glass jug (3) can be disassembled, especially for cleaning.
Remove the lid (2) and the closing cap (1). Place the glass jug (3) on the table
with the opening face-down and turn the locking screw (6) on the blade unit (5)
clockwise (see the figure). You can now remove the blade unit (5) and the sealing
ring (4).
To assemble the glass jug, the sealing ring (4) is first of all attached to the blade
unit (5). When doing so, ensure that the sealing ring (4) is correctly positioned on
the blade unit (5). Then insert the blade unit (5) into the glass jug. (3) and firmly
turn the locking screw (6) anti-clockwise.
Note: To ensure the tightness of the glass jug (3), the blade unit (5) must be
screwed on tightly. The blade unit (5) is easier to tighten if you apply a few drops
of cooking oil on the sealing side of the glass jug (see the figure).
Cleaning and maintenance
Remove the mains plug after use. Under no circumstances should you immerse
the drive unit (8) in water. Simply wipe the outside with a damp cloth. Do not
use any abrasive cleaning agents. Ensure that you do not injure yourself on the
sharp blade when cleaning the glass jug (3). Immediately after blending, fill
the jug with warm rinsing water and allow the motor to run for a few seconds.
Then remove the glass jug (3) and clean with a washing-up brush. For thorough
cleaning, you can disassemble the glass jug as described in the section entitled
"Disassembling the glass jug".
For quick and easy cleaning, you can place all loose parts in the dishwasher.
13

Publicidad

loading