Waeco PerfectPower PP1002 Instrucciones De Montaje Y De Uso página 35

_PP1000_PP2000.book Seite 35 Donnerstag, 16. Oktober 2008 4:53 16
PerfectPower
Connecting the inverter to the 230 V mains supply
➤ Plug the 230 V connection cable into the connector for the 230 V power
supply to the inverter (fig. 1 2, page 3).
➤ Connect the 230 V connection cable to a 230 V socket in the vehicle.
Connecting the remote control to the inverter
➤ Switch off the inverter.
➤ Insert the cable end of the remote control into the connection (fig. 2 2,
page 3).
➤ Set the main switch (fig. 2 1, page 3) to "Remote".
Connecting the external switch to the inverter
➤ Switch off the inverter.
➤ Connect external switch at the remote port according to the circuit
diagram (fig. 2 3, page 3):
– external switch, voltage supply from the inverter
– external switch with its own voltage supply, e.g. from the ignition
➤ Set the main switch (fig. 2 1, page 3) to "Remote".
8.3 Connecting multiple consumers
Warning – Danger of electrocution!
e
If you wish to connect more than one consumer to the inverter and
install a socket distribution circuit, you must arrange a circuit
breaker (residual current circuit breaker) and set a grounding
bridge in the inverter. The grounding bridge may only be connected
by a trained professional who is familiar with the relevant VDE
(German Engineering Society) regulations.
The device is equipped at delivery with galvanic isolation. For the safe
operation of multiple consumers, it is essential that a circuit breaker (residual
current circuit breaker) is built into the socket distribution circuit, see sample
circuit diagram in fig. 6, page 5.
www.busse-yachtshop.de | info@busse-yachtshop.de
Fastening and connecting the inverter
35