Maintenance And Inspection - Hitachi DH 30PB Manual De Instrucciones

English

MAINTENANCE AND INSPECTION

WARNING:
1. Inspecting the drill bits
Since use of a dull tool will cause motor malfunctioning and degraded efficiency,
replace the drill bit with a new one or resharpening without delay when abrasion
is noted.
2. Inspecting the screws
Regularly inspect all screws and ensure that they are properly tightened. Should
any of the screws be loosened, retighten them immediately.
WARNING:
3. Maintenance of the motor
The motor unit winding is the very "heart" of the power tool. Exercise due care
to ensure the winding does not become damaged and/or wet with oil or water.
4. Inspecting the carbon brushes: (Fig. 20)
The motor employs carbon brushes which are consumable parts. When they
become worn to or near "wear limit", it could result in motor trouble. When an
auto-stop carbon brush is equipped, the motor will stop automatically. At that
time, replace both carbon brushes with new ones which have the same carbon
brush Nos. shown in the figure.
In addition, always keep carbon brushes clean and ensure that they slide freely
within the brush holders.
CAUTION: Using this rotary hammer with a carbon brush which is worn in
excess of the wear limit will damage the motor.
NOTE: Use HITACHI carbon brush No.73 indicated in Fig. 20.
18
Be sure to switch power OFF and disconnect the plug from the
receptacle during maintenance and inspection.
Using this rotary hammer with loosened screws is extremely
dangerous.
73
0.67" (17 mm)
Fig. 20
Wear limit
No. of carbon brush
0.28" (7 mm)