EINHELL TC-DH 1600/1 Manual De Instrucciones página 25

8. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the mains power plug before star-
ting any cleaning work.
8.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
8.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualifi ed electrician.
Danger! The carbon brushes should not be rep
laced by anyone but a qualifi ed electrician.
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.3.1 Check the oil level (Fig. 6)
Check the oil level before using the machine.
Place the machine on the fl oor with the tool
mounting pointing downwards. The oil must be at
least 3 mm above the bottom edge of the inspec-
tion window (6).
Changing the oil: The oil should be changed after
around 40-50 hours of use.
Recommended oil: 45ml SAE 15W/40 or an alter-
native of the same quality.
8.3.2 Oil change (Fig. 7)
Switch off the machine and pull the mains plug
out of the socket.
Undo the hexagonal head screw with the inspec-
tion window (6) using the wrench (7) and drain
the oil. To prevent the oil from running out in an
uncontrolled manner, hold a small metal chute
under the opening and collect the oil in a vessel
until it has fully drained out of the machine.
Anl_TC_DH_1600_1_SPK8.indb 25 Anl_TC_DH_1600_1_SPK8.indb 25
GB
Important: The waste oil must be disposed of in
the appropriate collection point for waste oil.
Add new oil (approx. 45 ml) through the oil fi ller
opening (6) until the oil level reaches the required
level. Tighten the hexagonal screw again.
Re-check the oil level after a short period of ope-
ration.
8.4 Ordering spare parts
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
9. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
10. Storage
Store the equipment and accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30
°C. Store the electric tool in its original packaging.
- 25 -
08.03.16 11:02 08.03.16 11:02