Overview; Commissioning; Attaching The Additional Handle; Attaching The Safety Guard - Cibo Finit-All SMFA 2018 Manual De Instrucciones

EN
Sweeping or blowing stirs up dust.
- Vacuum or wash protective clothing. Do not
blow, beat or brush.
6.

OVERVIEW

See page 2.
1 Clamping nut
2 Finit-All Support flange
3 Spindle
4 Spindle locking button
5 Safety cover
6 Side handle
7 Sliding on/off switch
8 Handle
9 Electronic signal indicator
10 Speed adjustment wheel
11 Switch-on lock
7.

COMMISSIONING

Before plugging in, check that the rated
mains voltage and mains frequency, as
stated on the type plate match your power
supply.
Always install an RCD with a maximum trip
current of 30 mA upstream.

7.1 Attaching the additional handle

Always work with the additional handle (6)
attached! Attach the additional handle on
the left or right of the machine and secure.

7.2 Attaching the safety guard

Safety guard for grinding
Designed for work with roughing wheels, flap
sanding pads, diamond cutting discs.
See illustration A on page 2.
• Place the safety guard (5) in the position
32 Ι Finit-All
indicated.
• Push the lever (11) and turn the safety guard
until the closed section is facing the operator.
• Release lever and rotate guard until the lever
latches.
• Make sure that the guard is placed securely:
The lever must engage and you should not
be able to turn the safety guard.
8.

USE

8.1 Adjusting the speed

Set the recommended speed at the thumb-
wheel (10). (small number = low speed; large
number = high speed)

8.2 Switching On and Off

Always guide the machine with both
hands.
Switch on first, then guide the accessory
towards the workpiece.
The machine must not be allowed to draw
in additional dust and shavings. When
switching the machine on and off, keep it
away from dust deposits. After switching off the
machine, only place it down when the motor
has come to a standstill.
Avoid inadvertent starts: always switch the
tool off when the plug is removed from
the mains socket or if there has been a
power cut.
Manual
Finit-All
Use only accessories that
are covered by at least 3.4
mm by the safety guard.
(Disassemble in reverse
order.)