Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Installing/Replacing the lamp
For the installation, you need one of the following lamps, depending upon device version:
OMNILUX ES-32W spiral G5 6400K T5 5000h
OMNILUX ES-42W spiral G5 6400K T5 5000h
The lamp life given by the manufacturer must never be exceeded.
Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 10 minutes).
During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
Procedure:
Step 1: Unscrew the cover screws.
Step 2: Remove the cover.
Step 3: If replacing the lamp, remove the old lamp from the lamp holder.
Step 4: Insert the lamp into the lamp holder.
Step 5: Replace the cover.
Step 6: Tighten the cover screws.
Overhead rigging
The installation of the projector has to be built and constructed in a way that it can hold 10 times the weight
for 1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
Do not operate this device with opened cover!
13/28
9200391U
9200392U
00038106.DOC, Version 1.1
Publicidad
Tabla de contenido
