Alder USV-24-300T Manual De Servicio página 71

(MSDS: 722330)
Prevent spilled material from entering sewers, storm drains, other unauthorized drainage systems, and natural
waterways. Dike far ahead of spill for later recovery or disposal. Spilled material may be absorbed into an
appropriate absorbent material.
Notify fire authorities and appropriate federal, state, and local agencies. Immediate cleanup of any spill is
recommended. If spill of any amount is made into or upon navigable waters, the contiguous zone, or adjoining
shorelines, notify the National Response Center (phone number 800-424-8802).
7. HANDLING AND STORAGE
Handling:
Do not enter confined spaces such as tanks or pits without following proper entry
procedures such as ASTM D-4276 and 29CFR 1910.146. The use of appropriate respiratory protection is advised
when concentrations exceed any established exposure limits (see Sections 2 and 8).
Do not wear contaminated clothing or shoes. Use good personal hygiene practices.
High pressure injection of hydrocarbon fuels, hydraulic oils or greases under the skin may have serious
consequences even though no symptoms or injury may be apparent. This can happen accidentally when using
high pressure equipment such as high pressure grease guns, fuel injection apparatus or from pinhole leaks in
tubing of high pressure hydraulic oil equipment.
"Empty" containers retain residue and may be dangerous. Do not pressurize, cut, weld, braze, solder, drill,
grind, or expose such containers to heat, flame, sparks, or other sources of ignition. They may explode and
cause injury or death. "Empty" drums should be completely drained, properly bunged, and promptly shipped to
the supplier or a drum reconditioner. All containers should be disposed of in an environmentally safe
manner and in accordance with governmental regulations.
Before working on or in tanks which contain or have contained this material, refer to OSHA regulations, ANSI
Z49.1 and other references pertaining to cleaning, repairing, welding, or other contemplated operations.
Keep container(s) tightly closed. Use and store this material in cool, dry, well-ventilated
Storage:
areas away from heat and all sources of ignition. Store only in approved containers. Keep away from any
incompatible material (see Section 10). Protect container(s) against physical damage.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Engineering controls:
the established exposure limits (see Section 2), additional engineering controls may be required.
Personal Protective Equipment (PPE):
Respiratory:
filter may be used under conditions where airborne concentrations are expected to exceed
exposure limits (see Section 2).
Protection provided by air purifying respirators is limited (see manufacturer's respirator
selection guide). Use a NIOSH approved self-contained breathing apparatus (SCBA) or
equivalent operated in a pressure demand or other positive pressure mode if there is
potential for an uncontrolled release, exposure levels are not known, or any other
circumstances where air purifying respirators may not provide adequate protection. A
respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2
requirements must be followed whenever workplace conditions warrant a respirator's use.
Skin: The use of gloves impervious to the specific material handled is advised to prevent skin
contact and possible irritation (see manufacturers literature for information on
permeability).
Eye/Face:
injury is recommended. Depending on conditions of use, a face shield may be necessary.
P/N 90103-S, Rev. 0
If current ventilation practices are not adequate to maintain airborne concentrations below
A NIOSH certified air purifying respirator with a Type 95 (R or P) particulate
Approved eye protection to safeguard against potential eye contact, irritation, or
Page 4 of 7
Página 59