IMG STAGELINE ATS-40R Manual De Instrucciones página 10

GB If the right symbol flashes, the batteries
should be replaced (
rechargeable
recharged (
2) Adjust the transmitting channel on the
transmitter with the buttons
and select the same receiving channel on
all receivers in the same way. (For fast run-
ning through the channel numbers, keep
the buttons pressed for a longer time.)
Once the receiver receives a signal
from the transmitter, its operating light (2)
shows green. If it shows red even if the
transmitter is switched on and the channel
is adjusted identically, or if the reception is
poor or disturbed, check if
– the distance to the transmitter is too
large.
– the reception is better on another
channel.
– the reception is disturbed by objects
in the transmission path.
3) Talk into the integrated microphone (6) or
the connected microphone (9) on the
transmitter. Adjust the desired volume on
the respective receiver with the small
wheel (16).
4) To prevent unnecessary battery consump-
tion, switch off the units after use. For this
purpose keep the button
approx. 2 s. The display (3) shows "OF"
(off) and will then extinguish.
In addition, the units will be switched off
automatically if no microphone signal or
wireless signal has been received for ap-
prox. 30 minutes or the batteries are too
weak.
10
chapter 4.1) or the
batteries should
chapter 4.2).
(5) pressed for
6 Note Concerning
Multichannel Operation
be
(simultaneous operation of several ATS-40
systems)
A maximum of 10 transmission systems trans-
and (4)
mitting on different channels can be used at
the same time. The number of the channels
which can be used in parallel depends on the
distance between the individual transmission
systems (at least 5 m between the transmit-
ters), on any local RF interference sources
and other local conditions.