OEM MILLENIUM VALIDO Manual De Uso Y Mantenimiento página 74

5.2.a - Oven starting (Fig: 13)
• Close the chimney by positioning the handwheel (A)
on to close the damper.
By turning towards
by turning towards
• Press the key , the display (1) lights up.
• On the display (1) the real oven temperature is dis-
played.
• Set the baking temperature by pressing the key
or , the temperature value will be displayed on
the display (1). Operate the key
or reduce the temperature.
• Adjust the ceiling heating element operating percen-
tage using the knob (3) and the floor heating element
operating percentage using the knob (4).
• Wait until the oven reaches the set pizza baking
temperature which will be indicated by a lighting up
of the led (5).
• Open the chimney by positioning the handwheel (A)
on to open the damper.
5.2.b - Self-starting programming (Fig. 13)
• The oven can be set to automatically self-start by
installing an external timer upstream of the main
switch.
To activate or deactivate this function, operate as
follows:
- With the oven off, press and hold down the
button (2) and keeping it pressed down, turn on the
oven with the upstream main switch.
• You access the A-x page where:
x=0 Self-starting OFF
x=1 Self-starting ON
If you do not make any change for 3 seconds, the
board takes the data shown on the display and turns
off.
ATTENTION
Do not disconnect the power supply upstre-
am of the oven.
EN - 26
, the chimney damper opens;
, the chimney damper closes.
or to raise
FIG. 13
"
2
MILLENIUM VALIDO
Functioning
A
1
5
3
4