How To Use; Maintenance - Fenix ELV-300/6 Instrucciones

Ocultar thumbs Ver también para ELV-300/6:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. HOW TO USE

1. Place the lifting tower over a firm and flat
surface on its working place.
2. Remove the pin (Q) and fix it (R). Activate
the tensor (P) in all its outriggers until the lif-
ting tower is stable on the surface.
3. Put the load on top of the lifting tower
using a suitable support, in order to make the
weight work only in vertically. The minimum
load must be 25kg. It is possible to manually
block it with the safety pins (A).
4. Elevation: Turn the winch handle (B) cloc-
kwise to lift the load until the wished posi-
tion, checking that safety pins (A) are acti-
vated (T).
5. Lowering: release the safety pins (A) doing
the action U. To release them, turn slightly the
winch handle to elevate the load. In the nor-
mal working position, the load's weight does
not allow to release the safety pins. Once the
safety pin (A) is unblocked, turn the winch
handle (B) anticlockwise until lowering the
load and the first profile is completely down.
Release the safety pins (A) and keep on lowe-
ring the lifting tower until the second profile
is completely down. Unblock the safety pin
(A) and continue lowering the lifting
Fig. 1
S
T
U
A
B
J
Q
P
R
tower until it is completely folded at its mi-
nimum height. The lifting tower can be fixed
at any needed intermediate position as well
as when raising the load, fixing the safety pin
(A) in the position (S).
6. For the lifting towers' transport it is neces-
sary to bring down all the profiles, releasing
the safety pin (A) doing the action U. To fix
the profiles with the safety pins (A) in the po-
sition (S).

5. MAINTENANCE

1. Periodically check cable status. If the cable
seems to have broken cable wires or crus-
hing, replace immediately with a new one.
Never use the lifting tower with cables in bad
conditions. Only use galvanized steel under
EN 12385-4. Cable maximum load: 2.150kg.
Cable torsion resistance: 1.770N/mm². Cable
diameter: 6mm. Cable composition: 7x19+0.
2. The lifting tower is supplied fully greased
from factory. Nevertheless, the crown gear of
the winch, to the threaded bar of the stabili-
ser outriggers and the profiles, because of its
use periodical greasing is recommended.
WARNING:
DO NOT GREASE OR LUBRICATE BRA-
KING MECHANISM
Braking disks were greased with a special
heat and pressure resistant grease. No other
product must be used to prevent negative in-
fluence on brake functioning.
3. Lifting tower ELV-230/5, must be checked
by an expert a minimum of once a year mini-
mum as per its use.
4. Only original spare parts must be used to
ensure continued safe use. The user loses all
guarantee rights if spare parts other than the
originals are incorporated or the product is
modified in any way.
5. To request any spare part, contact the
manufacturer or an authorised distributor
within your territory.
www.audiovias.com
ENGLISH
13 13

Publicidad

Tabla de contenido
loading

Tabla de contenido