KENMORE ELITE 580.77107710 Manual De Uso página 10

INSTALLATION INSTRUCTIONS
Use 2 type A screws to attach a sill support to the
4
cabinet track holes on one side. Use the cabinet
track holes that will place the sill support nearest to
the outer edge of the sill. Repeat with the second sill
support on the opposite side of the cabinet.
Install the cabinet with a slight tilt (about ½")
5
downward on the outside.
Use the bolt and nut to adjust the tilt of the cabinet.
CAUTION
Do not drill a hole in the bottom pan. The product
is designed to operate with approximately ½" of
water in the bottom pan. There is no need to add
water if the pan is dry.
Attach the cabinet to the inside sill by driving 3 type
6
B screws through the cabinet front angle and into
the sill.
Screws (Type B)
NOTE: If the gap between the bottom of the
cabinet and the inside sill is too great, install a wood
strip to make up the difference. See the Clearance
instructions for details.
Screws (Type A)
Outdoor
Indoor
½"
about
Cabinet
Sash Track
Front Angle
Pull each curtain panel out to the side until it meets
7
the window sash track. Pull the bottom window sash
down behind the upper guide until it meets the top
of the cabinet.
NOTE: Do not pull the window sash down so tightly
that the movement of the curtain panels is restricted.
Use a screwdriver or power drill to attach the
8
curtain panels to the window sashes by driving type
C screws into the sashes through the cabinet holes
shown in the figure below.
With the aid of an assistant, slide the unit into the
9
cabinet. Reinstall the screws removed from the
cabinet sides in step 1.
CAUTION
• The unit is heavy. Use an assistant to help lift the
unit and set it in place. Lifting and maneuvering
the unit by yourself could result in injury.
• Hold the unit firmly in place until the window
frame is lowered to meet the top surface of the
unit directly behind the upper guide. If the unit
falls from the window, it could cause personal
injury or property damage.
10
Upper Guide
Sash Track
Inside Window Sill
Front Angle
Screws (Type C)