Dolmar PT-2000 Instrucciones De Montaje página 6

A
5
B
C
12
11
D
6
2
1
6
3
4
13
8
11 10
Guide trolley control shaft
Loosen star handle (1).
Fold control shaft (2) upwards in the direction of the arrow.
Tighten star handle (1).
NOTE:
Depending on body size, adjust control shaft to working height
after mounting the power cut.
Mounting the adapter set
Place support plate (3) on guide trolley (4) as shown in illus-
tration.
Fit the screws and nuts (see illustration), do not tighten nuts
for the moment.
Fit eccentric plate (5) with quick-action lever (6).
NOTE:
Pulling the quick-action lever cancels out the screw effect. It
can be tightened up by pulling the lever again.
Adjust support plate, aligning notches.
Now tighten nuts firmly, as shown in figure B.
Thread cable (7), as shown in picture, through the adapter
bracket (8), the compression spring (9), the gas operating de-
vice (10) and the Bowden cable sleeve (11).
Thread cable end through the gas lever (12) and pull on the
cable end until the cable has been completely threaded through
and the Bowden cable sleeve (11) is resting in the support of
the gas lever (12).
Press Bowden cable sleeve into the support (13) on the con-
7
trol shaft.
NOTE:
Only tighten the clamping screw on the gas lever (12) slightly
to prevent the cable slipping out again. The gas lever is set
9
correctly when the power cut is mounted (see "Mounting the
power cut").