Quick Start - Intel 550F Guia De Inicio Rapido

Quick Start

Install the Express
1
550F Switch
Place the switch in a rack or on a shelf or
table, plug the cord in, and turn the power
on.
Connect devices
2
to the Switch
For 62.5/125 mm fiber, the length of a full-
duplex link cannot exceed 2,000 meters
(approximately 6,500 feet).
3
Check port LEDs
• Verify that the Power LED is green.
• The Port LEDs reflect the state of each port:
Green
Off
Blinking randomly
Solid
Blinking randomly
Off
Solid
Orange Meaning
Off Port enabled, no link.
Off Port enabled, Rx/Tx traffic, link pulse active.
Off Port enabled, link pulse active.
Blinking randomly Collision detected. Port enabled, link pulse active.
Solid Port disabled by hardware failure or management.
Solid Port disabled by a fault, or no hardware connected.
Slot A Slot B
1 2 3 4 5
TX RX TX RX TX RX TX RX TX RX TX
Rubber feet for shelf or table placement.
Brackets and screws for standard
19-inch equipment rack placement.
Slot A
1 2 3 4 5
TX RX TX RX TX RX TX RX TX RX
Slot A Slot B LEDs Green Orange
Off 10 Mbps Half duplex Intel Express
Solid 100 Mbps Full duplex 550F Routing
Por t Status Switch
Status Power
LEDs Green Orange Temperature
Solid Link Disabled Reset
Blink Activity Collision RPS
1 2 3 4 5 6 7 8 Console
TX RX TX RX TX RX TX RX TX RX TX RX TX RX TX RX 9600-8-N-1
LEDs Green Orange
Off 10 Mbps Half duplex Intel Express
Solid 100 Mbps Full duplex
550F Routing
Por t Status Switch
Status Power
LEDs Green Orange
Temperature
Solid Link Disabled
Reset
Blink Activity Collision RPS
Console
6 7 8
RX TX RX TX RX 9600-8-N-1
1660
Slot B
LEDs Green Orange
Intel Express
Off 10 Mbps Half duplex
Solid 100 Mbps Full duplex
550F Routing
Por t Status Switch
Status Power
LEDs Green Orange
Temperature
Solid Link Disabled
Reset
Blink Activity Collision RPS
Console
6 7 8
TX RX TX RX TX RX 9600-8-N-1
1662
1