Tabla de contenido
Publicidad
MAINTENANCE MODE - LCD
Maintenance Mode allows access to service and diagnostic information, as well as provides the ability to adjust certain
program default parameters. To enter Maintenance Mode:
1. Press and hold the
,
2. A beep will sound and "MAINTENANCE MODE" will display momentarily in the Information Window.
3. Release all keys. "SERIAL NO #####" will display in the Information Window.
The following keys are available in MAINTENANCE MODE:
Increase and Decrease LEVEL Keys: Adjust the value of the displayed parameter up and down, respectively, in
increments of 1 unit. These keys do not save the new value - see OK Key below.
Numeric Keypad: Allows you to enter specific values for numeric parameters. These keys do not save the new
value - see OK Key below.
OK Key: Updates (saves) the values of all parameters in non-volatile memory, and exits Maintenance Mode.
NOTE: To exit Maintenance Mode without saving any values or settings, press the QUICK START key.
A complete list of the items that you may display and change in Maintenance Mode:
Item
SN
DSW
LCB VERS
UNx
MAX TIME
and
keys together.
Min
Max
Default
0
65535
0
N/A
N/A
Vx.xx
N/A
N/A
Vx.xx
N/A
N/A
ENGLISH
5
99
99
Notes
Serial Number. Bike serial number (set by
factory).
Display Software. Display panel software
version number (set by factory). ( V.55
4A72CA5D )
LCB Software. LCB software version number
(set by factory). ( V2.05 )
Units. UNE (English) = units of pounds, miles,
feet, inches
UNM (Metric) = units of kilograms, kilome-
ters, centimeters
Time. Maximum time in minutes allowed
for a program, excluding warm-up and
cooldown.
Page 24
Publicidad
Tabla de contenido
