Publicidad
Idiomas disponibles
Idiomas disponibles
Fax +32 030 9904733
FIRST USE
Warning: always unplug the device before assembling, disassembling and cleaning the
appliance. Before each use, ensure that the clippers are in good working order, and that the
power cable is not damaged: if the cable is damaged, it must be replaced by the
manufacturer or its service centre or by someone with a similar qualification in order to
prevent any risks.
PRESERVING THE RECHARGEABLE BATTERY
To maximise the capacity and life of the rechargeable battery, it should be fully charged for 14 hours
before the first use and then fully discharged by using. Then recharge to full capacity (6 hours). This
discharging/charging procedure should be done every six months. Afterwards, leave the appliance to
charge for a time from 10 to 12 hours.You can also use the clippers with adapter connected to the
power outlet.
Lubricating the blades
For proper operation of the device, frequent lubrication of
the blades is required before each use. Add 1-2 drops of oil
onto the blades (see figure to the right) with a finger and
spread it over the entire surface of the blades. Switch on the
device (first plug it into the power outlet and then turn the
switch to pos. On.) for a short period, so that oil is
dispersed properly over all blades. Use only the oil supplied
or oil for sewing machines. Do not use hair oils, grease or
substances containing kerosene or any other solvent, as this
may evaporate and the residual oil may seep into the gears
of the blades.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
11
40
/
Assembly page 11/40
Publicidad
