Publicidad
General Guidelines
Please read the following instruction carefully and use the product accordingly.
Ÿ
Please keep this manual and hand it over when you transfer the product.
Ÿ
This summary may not include every detail of all variations and considered steps. Please contact us when
Ÿ
further information and help are needed.
Notes
Please check whether there is part that is broken or missing according to the shipping list after unpacking.
Ÿ
Please assemble this item strictly according to this instructions since it may have injury risk once it is assembled
improperly.
It is recommended to assemble this product on a soft surface to prevent scratching the floor.
Ÿ
The broken parts may affect the safety and function. Please do not use this item when there are broken or
Ÿ
missing parts.
Attention: Please distinguish between right and wrong in the process of assembling the plastic recliner. Please
Ÿ
align screws to pre-drilled holes first and tighten screws later. It should be installed by two adults.
The seat will be raised after pressing down the knob under the seat. However, the seat will be lowered by the
Ÿ
same operation if there is a person on the seat. You will have a free backward tilt if you pull the knob outwards.
The backrest will be locked and unable to tilt backwards if you push the knob inwards.
The handle on the left side of the item is to adjust the backrest angle. You can adjust the angle by pressing up
Ÿ
the handle and trying hard to tilt backwards. Please release the handle when the angle is suitable and this angle
is fixed.
Attention: In case of turnover, please remember to push the knob inwards to fix the backrest when you are
Ÿ
leaning against it.
Do not adjust the backrest while using the tilt mechanism.
Ÿ
Please lean against the backrest to avoid injuring your head by the resilience force in the process of adjusting
Ÿ
the backrest to the vertical position by the handle.
Attention: The backrest can be adjusted by a knob under the seat. It is not recommended to lean backwards
Ÿ
abruptly to prevent tipping.
Keep your feet on the ground while resting in this chair; to prevent toppling, do not lean back on the headrest
Ÿ
too hard.
Watch your hand while using the angle adjustor.
Ÿ
The item is only intended for indoor use and designed to be a seat for one person.
Ÿ
The static maximum load of the item is 150 kg while that of armrests is 68 kg
Ÿ
To avoid damaging the chair, it is not recommended to just use one side armrest to support the whole body
Ÿ
weight.
Do not heat or disassemble the gas spring mechanism. The professional technicians should only be in charge of
Ÿ
maintaining the gas spring mechanism and height adjustable parts.
Never stand on the stool nor use it as a climbing tool.
Ÿ
It is forbidden to expose the item under the sunshine. It is also recommended to keep this item far from other
Ÿ
sharp items to avoid damage.
Please locate the noise first when noise appears. The use of lubricating oil will greatly mitigate such problems.
Ÿ
EN
2
Publicidad
