R
C
O
EMOTE
ONTROL
Programming The Remote
The Universal Remote Control can be programmed to operate many manufacturers' components, using the component
function buttons for VCR, DVD, CABLE or DBS. Follow the procedures for programming your Remote Control with or
without a code for the component.
Determine the manufacturer of the component and look in the table for the code.
Programming With a Code
Procedure
•
Confirm that the external component is plugged in and operating.
•
Turn the component off.
ACTION
•
Press
and
•
Press appropriate component button on the Remote Control VCR, DVD, CABLE or DBS.
•
Enter the 3-digit component code using the Remote Control numeric keypad (0 ~ 9 buttons).
•
Press the Remote Control
Programming Without A Code
This procedure searches all codes and is called the "sequence method."
•
Confirm that the external component is plugged in and on.
•
Turn the component off.
ACTION
•
Press
and
•
Press appropriate component button on the Remote Control.
•
Press VOL
to move forward to the next code. Press
•
Press the Remote Control
Note:
Repeat the above steps until the component code is found. It may take many attempts before the correct code
is found.
•
After the code is found, press
12
PERATION
Default Modes For Remote Control
Device
TV
TV (Panasonic Only)
VCR
DBS
CABLE
CABLE (Preset)
DVD
DVD, CD (Preset)
POWER
together, for at least 5 seconds.
to test the component. If the procedure was successful, the component will turn on.
POWER
Helpful Hints: Unsuccessful Code
If the component does not operate with the Remote Control, repeat
the procedure using another code. (Some brands have multiple
codes).
If an incorrect code is entered, or if the procedure takes longer than
30 seconds, the programming will fail.
together, for at least 5 seconds.
POWER
to test the component. If the procedure was successful, the component will turn on.
POWER
ACTION
to store the code.
Operates
Panasonic TV Codes
VCR (Preset)
Panasonic VCR Codes
DBS (Preset)
Panasonic DBS Codes
Panasonic DBS Codes
Panasonic DVD Codes
VOL to move backward.
Default