Product Specifications - Homewerks Worldwide Home2O 3F169BDCH Manual De Instrucciones

PRODUCT SPECIFICATIONS

SPECIFICATIONS
Max. Flow Rate: 2.5 GPM (9.5 LPM) at 80 PSI
ASME A112.18.1/CSA B125
ASSEMBLY INSTRUCTIONS
1. Remove existing showerhead with
wrench (not included). Clean threads
of shower arm.
2. Apply PTFE tape onto the threads of
the shower arm in a clockwise
direction, overlapping
1/2 in. width of tape.
ADJUSTING SPRAY SETTINGS
1. Adjust the sensor to a positition that
works best for you.
LED Temp
Display
1
2
1
NSF 61-9
Polished chrome finish
3. Check the new showerhead to be
sure that the washer is in place.
Carefully align threads.
4. Install new showerhead to shower
arm and hand tighten (do not
overtighten). Turn on water and
check for leaks.
NOTE: Showerhead can be
installed to either a ceiling mount
or wall mount shower arm.
2. Wave your hand in front of the
sensor to change between spray
settings.
2
SPECIFICATIONS
3
4
2
www.homewerksww.com
Washer