Maxtec Blender Buddy Instrucciones De Uso página 5

INSTRUCTIONS FOR USE
1. Insert small o-ring
2. Attach the small adapter block
H
bolt and provided hex key (No teflon tape is necessary). Remove any fittings
from the left side blender outlet if necessary.
*Skip to Step 9 if flow meters are already attached.
3. Wrap both threaded ends of the pipe nipples
4. Use a 7/16" wrench to tighten the pipe nipples
F G
flow meters
5. Tighten one assembled flow meter
large block A .
6. Remove the clear flow tube and shield from the other flow meter
flow meter components are arranged for reassembly in a subsequent step.
7. Tighten the disassembled flow meter
large block A .
8. Reassemble the flow meter
9. Insert large o-ring
10. Ensure white material is inside the bleed port on the end of the large block.
11. Attach large block
12. Supply gas to the blender and check for leaks and proper function.
WARNINGS
» Carefully read instructions provided with fl ow meters, as well as this insert, before use.
» For use with air/oxygen blenders only.
» Max pressure is 100 psi.
» Do not use lubricants on o-rings.
» Check for leaks after assembly.
» Not for use in MRI Environments.
» Maxtec assumes no responsibility for any damage or injury caused by improper installation,
assembly or use of this product.
» Replace EPDM o-rings during recommended blender rebuild. Use Maxtec approved o-rings.
» This product should only be used under proper supervision of a healthcare professional.
» If components are damaged or missing, contact your dealer immediately.
» DO NOT use substitute parts.
» Clean often using a cloth moistened with 65% isopropyl alcohol/water solution or germicidal
wipe.
» Follow all recommendations provided in the manual for the connected blender.
WARRANTY
» 2-year limited warranty on manufactured defects.
Manufacturer
LOT Lot code/Batch code
Attention, consult accompanying
documents
866.4.Maxtec
D into the small adapter block
B to the left side of the blender using the short
.
G into one of the threaded holes on the
F into the other threaded hole in the
F .
I into o-ring groove of the large block
A to small block B with the two long screws
EC REP
REF Catalog Number
www.maxtecinc.com
B .
E
with teflon tape (1-1/2 wraps).
E into the threaded holes of the
F
A .
Authorized Representative in the
European Community
. Note how the
C .
1