Technical Parameters; Rating Data - GRAPHITE PRO 59GP400 Instrucciones De Uso

REPLACEMENT OF THE CHUCK
The chuck is screwed onto the thread of the spindle and also secured with a screw.
Set the rotation direction switch (5) in the central position.
Open the jaws of the chuck (1) and unscrew the fixing screw (left-hand thread) (fig. H).
Put an Allen key in the chuck and gently tap the other end of the key.
Unscrew the chuck.
In order to install the chuck, perform the above actions in a reverse order.
Any and all defects must be removed by service companies authorized by the manufacturer.

RATING DATA

Parameter
Battery voltage
Battery type
Battery capacity
USB Power Bank
Range of idle rotational speed
Range of chuck
Range of torque control
Max. torque (soft drive)
Max. torque (hard drive)
Protection class
Weight
Year of manufacture
Parameter
Supply voltage
Supply current frequency
Charging voltage
Max. charging current
Charging time
Protection class
Weight
Year of manufacture
NOISE AND VIBRATIONS DATA
Information on noise and vibrations
The emitted noise levels, such as the level of emitted acoustic pressure Lp
Lw , and the measurement uncertainty K are given below in the instruction in accordance with the EN
A
60745 standard.
The vibration values a
EN 60745-2-1 standard, are given below.
The vibration level given below in this instruction was measured in accordance with a measurement
procedure set forth in the EN 60745 standard and can be used for comparing power tools. It can also be

TECHNICAL PARAMETERS

Cordless drill/driver
gear I
gear II
and the measurement uncertainty K, determined in accordance with the
h
0-1500 min
1–15 + drilling
Charger
25
Value
18 V DC
Li-Ion
2500 mAh
5 V DC (1A)
-1
0-400 min
-1
1,5-13 mm
40 Nm
68 Nm
III
1,6 kg
2016
Value
230 V AC
50 Hz
21 V DC
2500 mA
1 h
II
0,58 kg
2016
and the level of acoustic power
A