Craftsman 31014 Manual Del Operador página 3

operatioN
Note: Not all operation instructions will relate to your model.
tHe LocKBar for tHe roLL-aWay is storeD iN a
sLot iN tHe top froNt corNer of tHe uNit.
to LocK roLL-aWay
process:
▪ insert the straight end of the lockbar into the slot in the
base.
▪ Move the lockbar toward the unit until the bent end fits
into the slot near the lock.
▪ Lock with the key.
NOTE: if your unit is equipped with a storage compartment
with a panel at the bottom, pull panel out, lift up and push
panel back into unit to gain access to compartment.
removiNG DraWers
• Empty the drawer.
• Fully extend the drawer.
All manuals and user guides at all-guides.com
Release
3
Lever style - Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Pull out to remove.
tab style - depress the release tabs on both sides,
(this allows the slides to ride over the stops.)
Pull out to remove.
friction style - Fully extend the drawer. insert screwdriver
into the slot in the side and push in on the stop until it
clears the lance. Pull drawer just past lance before
releasing stop. Repeat the process for the other slide.