Installation; Programming; Audio Level Adjustment - Axxess AXTO-CH2 Instrucciones De Instalación

INSTALLATION

1. Connect the 16-pin harness, and the AXTO-CH2 harness, to the AXTO-CH2 interface.
2. Connect the AXTO-CH2 harness to the wiring harness in the vehicle.

PROGRAMMING

Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
1. Cycle the ignition on and wait until the radio comes on.
Note: If the radio doesn't come on within 60 seconds, cycle the key off, then unplug the
interface. Check all connections, reconnect the interface, then try again.
2. Cycle the ignition off, then back on.
3. Test all functions of the installation for proper operation.

AUDIO LEVEL ADJUSTMENT

1. With the vehicle and radio turned on, turn the volume up 3/4 of the way.
2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counterclockwise to lower the audio level.
3. Once at a desired level, audio level adjustment is complete.
REV. 10/10/2019 INSTAXTO-CH2
3