Installation; Notice - Lacor 69411 Instrucciones De Uso Y Mantenimiento

1.- Open the large box. Remove all packing materials and protective covering from the unit and
parts. Do not discard the wrapping until you have checked that the blender is working
correctly.
2.- Place the base on a large, flat, hard area
3.- Fix the lower part of the main post to the base, using the M6x10 mm screws provided
4.- Insert the base protector trim through the tube and place on the base.
5.- Tie the tubes to the top of the post using up the remaining length.
6.- Insert the cable, plug end first, in through the hole at the top of the main panel and out from
the hole at the bottom, leave a length of 4 cm the top of the main panel. You may require
some help with this section.
7.- Take the heating lamp and align it with the main panel to connect the ends of the electrical
connectors. Close the box provided.
8.- Align and insert the holes and grooves of the lamp, with the holes in the main post, then
secure with the d.2x10 mm screws provided.
9.- At the bottom of the base you will find some flanges to secure the cable ties and to prevent
a tug on the very same cables, from disconnecting the heating lamp, fasten the cables with
said flanges.
10.- Make sure the switches are OFF before connecting the cable to the correct power supply.
* The power supplied to this unit must comply with electrical requirements on it's label.
Damage or fire may result if the incorrect power is used.
* Turn off all switches and unplug the unit should an emergency situation occur.
* Keep hands and other body parts clear of very hot parts. Otherwise injuries may result.
Of this device or in the case of a unit being used which has been abused;
damaged either accidentally or intentionally, modified, improperly installed or used in any
manner contrary to those included in the product instructions, guantee will automatically be
canceled.
* The machine can not be washed or placed into water as it is not a waterproof device.
Putting the unit into water may result in electric shock and will damage the mechanical and
electrical components.
* Turn off and unplug the unit when performing maintenance or cleaning the unit.
* Turn the machine off if it appears to be operating in an unusual manner.
* Please contact the seller if you lose the operations manual for a replacement.
* Please contact the seller if you find other problems not covered in the operation manual.
INSTALLATION AND ASSEMBLY

NOTICE

24