Safety Instructions; User Servicing Instructions - Holiday Living & Design W11E0001 Manual Del Usuario

SAFETY INSTRUCTIONS

When using electrical products, basic precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Do not use seasonal products outdoors unless marked suitable for indoor and outdoor use. When products are

used in outdoor applications, connect the product to a Ground Fault Circuit Interrupting (GFCI) outlet. If one is not
provided, contact a qualified electrician for proper installation.
This seasonal use product is not intended for permanent installation or use.

Do not mount or place near gas or electric heaters, fireplaces, candles or other similar sources of heat.

Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.

Do not let lamps rest on the supply cord or on any wire.

Unplug the product when leaving the house, when retiring for the night, or if left unattended.

This is an electric product – not a toy! To avoid risk of fire, burns, personal injury and electric shock it should not

be played with or placed where small children can reach it.
Do not use this product for other than its intended use.

Do not hang ornaments or other objects from cord, wire or light string.

Do not close doors or windows on the product or extension cords as this may damage the wire insulation.

Do not cover the product with cloth, paper or any material not part of the product when in use.

This product is equipped with push–in type lamps. Do not twist lamp.

This product employs overload protection (fuse). A blown fuse indicates an overload or short-circuit situation. If

the fuse blows, unplug the product from the outlet. Also unplug any additional strings or products that may be
attached to the product. Replace the fuse as per the User Servicing Instructions (follow product marking for proper
fuse rating) and check the product. If the replacement fuse blows, a short-circuit may be present and the product
should be discarded.
Read and follow all instructions that are on the product or provided with the product.

For indoor and outdoor use.

SAVE THESE INSTRUCTIONS
CAUTION
To reduce the risk of overheating, replace burned-out lamps promptly. Use 2.5 volt lamps only.

To reduce the risk of fire and electric shock: a) do not install on trees that have needles, leaves or branch

coverings of metal or materials which look like metal, and b) do not mount or support strings in a manner that can
cut or damage wire insulation.
This lighting is rated 36 watts (0.3 Amps). Do not overload. Connect other lighting strings or decorative outfits

end-to-end up to a maximum of 210 watts (1.75 Amps) total.
If connecting to a lighting string that does not have a wattage (W) rating (found on the tag within 6 inches of the
plug), calculate the wattage as follows: Multiply the current (0.3 A) which is on the flag-type tag by 120.
For example: Lighting string is rated 120V, 60Hz, 0.3 Amps. 0.3 × 120 = 36 watts
TOTAL AMOUNT OF WATTAGE THAT CAN BE CONNECTED: 210 watts – 36 watts = 174 watts

USER SERVICING INSTRUCTIONS

Replace the fuse.
Grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling on the cord.

Open fuse cover. Slide open fuse access cover on top of attachment plug toward blades.

Remove fuse carefully.

Risk of fire. Replace fuse with only a 3 Amp, 125 volt fuse (provided with product).

Close fuse cover. Slide close the fuse access cover on top of attachment plug.

CAUTION:
Risk of fire. Do not replace attachment plug.
Do not remove the safety device (fuse). Discard product if the attachment plug is damaged.
2