Publicidad
Once you have the separate elements and the boom assembly, it is time to mount the plate to the boom and then the elements to the plate.
We recommend is that you start at the plate to the boom, if I mounted the antenna in one piece. If he wants to climb elements, since once the
boom to the mast, we recommend putting the elements to the plates for better union of the set "Plate / element" boom.
To add items to the plate, keep in mind that the 10mm Ø directors and reflector go on board EA010023 and the DRIVEN LOOP element to the
13mm Ø in the EA010026 plates. With the help of a tape measure, center the element in the center of the plate, and once focused, set green
plastics P0600066 for 13mm Ø elements and for 10mm Ø elements, the EAHYP010 holders.
Screws for fixing EAHYP013 and EAHYPD010 are DIN 912 M6x40 and DIN 912 M6x30 respectly.
DIN 985 M6
EA010022
20mm
To place each plate to the boom, are fixed by screws DIN 912 M6X20 and DIN 127 M6 washer. This plate must be very firm for positioning the
element. The next step would be like the other elements, but considering that the screws use are DIN 912 M6X40 / DIN 912 M6X40 and
DIN 985 M6 self-locking nuts once it is all assembled antenna.
S912-9630
DIN 912 6x30mm
4m Plates EA010022
S912-9620
DIN 912 6x20mm + DIN 127 M6
DIN 985 M6
ENGLISH
S912-9640
DIN 912 6x40mm
4m Plates EA010026
S912-9620
DIN 912 6x20mm + DIN 127 M6
FEEDING ELEMENT
EA010026
Publicidad
