A-iPower PWE2000 Manual Del Propietario E Instrucciones De Operación página 13

SETUP
ASSEMBLY:
5. Connect the High Pressure Hose to the
Pump outlet tting and tighten the nut
rmly by hand, DO NOT use any tool to
tighten for steps 3, 4, 5. See Figure E.
6. Connect the Pressure Hose to the
handle of the Spray Gun and tighten the
7. Insert the Wand into the Spray Gun tip
and tighten the nut rmly by hand. See
Figure G.
FOR TECHNICAL QUESTIONS, PLEASE CALL 1-855-888-3598
Figure E
See Figure F.
Figure F
Figure G
Wand
Spray Gun Tip
8. Attach the Nozzle to the Wand by
pulling back the quick connect collar
and pushing the Nozzle onto the end of
the Wand. Make sure the quick connect
collar locks the Nozzle in place.
See Figure H.
9. Connect the water supply hose to the
water inlet connection on the unit and
tighten the Inlet Fitting rmly by hand.
See Figure I.
The water source must be able to
provide a minimum of three gallons of
clean, cold water per minute at 20PSI.
Only use a 5/8" inner diameter, or larger
hose that is rated to meet this capacity.
11
Figure H
Nozzle
Quick Connect
Collar
Wand
Figure I