Audiovox PROFESSIONAl PS-130i Manual Del Sistema página 5

All manuals and user guides at all-guides.com
4b. If, before proceeding with step 1, the chirps were off, then you will hear 1 chirp to
indicate that the chirps have been turned on.
5. Whenever power to the system is disconnected ( for repair or service of the vehicle ),
the chirps will be active when the power is re - connected. To turn the chirps off, simply
execute steps 1 through 3 above.
NOTE: Whenever the chirps are by - passed, the 3 chirp defect and 4 chirp intrusion
indicator will always operate. This feature will always warn you if a zone is active
during arming or the vehicle was tampered with in your absence. This will occur even
if the normal arming and disarming chirps have been turned off.
REMOTE PANIC OPERATION (CHANNEL 1):
The arming button on your key chain transmitter also functions as a "panic" switch for
instant activation of the alarm in emergency situations. To use the remote panic switch;
1. Press and hold button #1 on the key chain transmitter for 3 seconds or more. The alarm
will immediately sound.
2. To stop the alarm, press and release button #1 on the key chain transmitter. If the
button is not pressed, the alarm will automatically stop after 60 seconds.
WARNING: Excessive pressure on the transmitter buttons will damage the
internal components on the circuit board. All that is required
is a light push to the button.
OPTIONAL FEATURES (CHANNEL 2 AND CHANNEL 3):
This security system has two additional features that can be wired or programmed to
operate a number of different optional accessories. Some of the more common uses for
these "channels" are;
* Remote Trunk Release - available for any vehicle with a factory installed electronic
push-button trunk release.
* Remote Car Starter - available for most automatic transmission, fuel injected vehicles.
* Remote Window Roll Up - available for most vehicles equipped with power windows.
* Garage Door Interface - available for use with electric garage door openers.
* Additional Vehicle Control - available to control a second vehicle equipped with a
similar PS-Series Audiovox alarm.
To activate the optional accessories;
1. Press button #2 on the keychain transmitter momentarily to activate it's option.
2. Press button #3 on the keychain transmitter momentarily to activate it's option.
NOTE: If either button #2 or button #3 are programmed to operate channel 2 of your
alarm, the button must be held for 3 seconds for activation, (consult your installation
center for more details).
Page 5
5 of 24