English - LevelOne PLI-3021 Manual Del Usuario

English

Hardware Installation
Ethernet Cable (RJ-45)
Powerline
Notebook
Front Panel LEDs
Normal Operation
The Powerline network is active.
This means that at least one
other HomePlug Device was
Ethernet connection is active
Configuration requires the use of Windows PC. Once configured, any device may be connected to the 200Mbps
HomePlug AV Adapter's Ethernet port. To perform configuration, follow the procedures list below.
1. Connect a RJ-45 Ethernet cable from the 200Mbps HomePlug AV Adapter's Ethernet port to your PC.
2. Connect a RJ-45 Ethernet cable from your xDSL/Cable Modem's Ethernet port to the other Powerline Ethernet
Adapter's LAN Ports.
3. Plug the200Mbps HomePlug AV Adapter into a power outlet.
4. Wait a few seconds for start-up to be completed, and then check the LEDs.

The LED should be ON.

The LED will be ON if other HomePlug devices are detected, otherwise it will be OFF.

The LED should be ON
Room 1
PC
On
detected.
Room 2
Flash
NA
- Data is being transmitted or
received via the Powerline
network.
Data is being transmitted or
received via the Ethernet Port.
- 4 -
Internet
ADSL / Cable Modem
Off
No Power
Powerline network is not available
- no other HomePlug devices were
detected.
No Ethernet connection