Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
5. Install Tank (A), (Fig. 5)
• Place brass washer (HH) followed by rubber
washer (II) onto bolt (JJ). Insert bolt (JJ) with
washers through hole inside the tank (A).
• Place brass washer (HH) followed by hex nut
(KK) onto bolt (JJ) protruding from bottom of
tank (A). Tighten hex nut (KK) to create a proper
and secure seal.
• Attach rubber sealing gasket (LL) to center drain
hole under tank (A).
• Gently place tank (A) on toilet bowl (B) with bolts
(JJ) protruding out underneath.
• Place oval metal washer (MM) followed by wing
nut (NN) onto the protruding bolt (JJ).
• Tighten wing nut (NN) enough so that the tank
(A) sits flat on the toilet bowl (B).
• Make sure the toilet tank (A) is parallel to the wall
and straight on the toilet bowl (B).
• CAUTION: DO NOT OVERTIGHTEN NUTS.
SEVERE DAMAGE MAY OCCUR.
6. Install Tank Lever Handle Assembly (D), (Fig. 6)
• Turn clockwise to remove plastic nut
(pre-assembled) from the lever arm.
• Insert lever arm through the hole on the left side
of tank. Screw the plastic nut (pre-assembled)
counterclockwise to tighten it.
• Hook the chain onto the lever. With the lever at
rest, the chain should only be long enough for
flapper to close.
7. Connect the Water Supply Line, (Fig. 7)
• Connect the water supply line (not included)
between the tank (A) and shut-off valve.
• Tighten the tank connection coupling nut ¼ turn
beyond hand tight. (DO NOT OVERTIGHTEN
THE TANK CONNECTION.)
• Turn on supply valve and allow tank (A) to fill.
• Check for leakage at all connections and tighten
or correct as needed.
II
JJ
KK
MM
NN
5
Fig. 5
HH
LL
Fig. 6
D
Lever Arm
Plastic Nut
Fig. 7
Publicidad
