habitat et jardin Fresh 7 Guia De Inicio Rapido página 5

Assemble Instructions
Set up your solar shower in a place that is exposed to direct sunlight as long as possible.
1. Connect shower head to black shower body tube.
NOTE: Don't use wrench. Don't forget the gasket.
2. Mount the shower base to concrete slab or wood base with four bolts, nuts and gaskets.
Recommend use wrench.
3. Put O-ring on the slot of lower tube. Lift shower upper tube on lower tube.
Turn locking ring clockwise to securely connect upper tube to lower tube.
NOTE: Handle and shower head need to face the same direction.
4. Connect hose adaptor to inlet of shower, then connect garden hose to hose adaptor and
water supply.
First Usage
1. Turn the shower handle to FULL ON HOT position.
NOTE: Filling tube with valve in hot position ensures no air pockets are trapped in shower.
This procedure is used for first usage only.
2. Turn on water supply to garden hose to fill the shower. It will take 3 to 4 minutes to fill up the shower.
3. When water flows from shower head, turn the shower handle off. Turning shower handle off makes water begin
heating in tube.
4. Depending on sunlight and outside temperature, the shower will take about 3 hours to fully heat water.
5. WARNING: To avoid scald, pay attention to turn shower handle to cold water (blue) direction before using the
shower. Then setting to desired temperature.
Winterization
1. Turn off and disconnect garden hose.
2. Open handle to full on hot position and allow water to drain from hose adaptor (about 5 minutes).
3. Push the safety locking upward. Then turn locking ring counterclockwise to separate upper tube and lower tube.
Unbolt lower shower tube and pour remaining water out of tube.
4. Clean and dry the shower parts. And move shower from outdoor to indoor. Store it in dry and warm place during
winter season, and prevent it from frostbite.
Warning
1．DO NOT USE SALT WATER OR ANTI-FREEZINE METHODS.
2．WATER PRESSURE: MAX 3.5BARS
3．ALWAYS START YOUR SHOWER FROM COOL TO AVOID SCALD.
For first time use, please let the water run out for several minutes to clean the shower inside and to take
away the smell of plastic and oil.
It is normal if some water dripping from the shower head after closing the tap, because water inside
expand after heating. It will stop in several minutes.
EN
5 2020-2021