Courtyard Creations TGS24CK Instrucciones De Montaje

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
PARTS LIST
PART
MATERIAL CODE
NO.
1
TGS24CK-CS01
2
TGS24CK-CS02
3
62TRS24KPY101
4
17C17A0403001YX
You will need the following tools:
- Phillips Screwdriver (Not included)
- Hex. Key Wrench (See Part #7)
- Hex. Key Wrench (See Part #8)
Step 1:
Place the table top (#1) onto a non-abrasive
surface, such as a carpet, with its underside
facing upwards. Insert the legs (#2) into the plastic
holders attached on the underside of the table top
(#1) rim. Fasten them together by using screws
(#4). See Figure 1.
Use the correct bolts as indicated. Do not tighten any of the bolts until the table is
!
completely assembled.
!
Do not sit or stand on this table.
! Do not discard of any of the packaging until you have checked that you have all of the
parts and fittings required.
Keep children away during assembly. This item contains small parts that can be swallowed
!
by children. Children should always be under direct adult supervision while using this product.
! Retain these assembly instructions for future reference.
! Quote the following FQC NO. when contacting the service center.
V-3
INTENDED FOR RESIDENTIAL USE ONLY.
TGS24CK
PART Q'TY
1
TABLE TOP
4
LEG
1
CENTER
CONNECTOR
4
SCREW ST4.2*12
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
DO NOT RETURN TO STORE!
STOP
PAGE 1 OF 2
PART
MATERIAL CODE
NO.
5
17C40A0705001YX
6
17FC05020601-YX
7
17KAA0101----Y4
8
17KAC3101----Y3
FIGURE 1
2
2
1
COURTYARD CREATIONS INC.
PART
BOLT M6*15
WASHER d6.5*D10*1.6
HEX. KEY WRENCH 4MM
HEX. KEY WRENCH 10MM
2
2
Q'TY
8
8
1
1
4