Machine Information; Technical Specifications - VONROC RH504AC Traducción Del Manual Original

EN
resulting in fire, explosion or risk of injury.
f) Do not expose a battery pack or tool to fire
or excessive temperature. Exposure to fire or
temperature above 130 °C may cause explosion.
NOTE The temperature „130 °C" can be replaced
by the temperature „265 °F".
g) Follow all charging instructions and do not
charge the battery pack or tool outside the
temperature range specified in the instructions.
Charging improperly or at temperatures outside
the specified range may damage the battery and
increase the risk of fire.
6) Service
a) Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
ADDITIONAL SAFETY WARNINGS FOR ROTARY
HAMMERS
a) Wear ear protectors. Exposure to noise can
cause hearing loss.
b) Use auxiliary handle(s), if supplied with the
tool. Loss of control can cause personal injury.
c) Hold power tool by insulated gripping surfaces,
when performing an operation where the cut­
ting accessory may contact hidden wiring or its
own cord. Cutting accessory contacting a "live"
wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
Electrical safety
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable for
the power rating of the machine with a minimum
thickness of 1.5 mm
cable reel, always fully unroll the cable.
6
. If you use an extension
2

2. MACHINE INFORMATION

Intended use
This rotary hammer is intended for impact drilling
holes in masonry such as brick, concrete and similar
material. It is also suitable for drilling in wood, metal,
ceramic and plastic. Furthermore, the machine can
be used as a demolition hammer in combination
with the SDS cold chisels provided. The machine is
on no account intended for other purposes.
Not suitable for construction site usage.

TECHNICAL SPECIFICATIONS

Model No.
Mains voltage
Mains frequency
Power input
No-load speed
Impact rate
Max. Drill diameter
- Concrete
- Steel
- Wood
Weight
Sound pressure (LPA)
Acoustic power (LWA)
Vibration
Hammer drilling concrete a
h,HD
Chiseling a
h,Cheq
Vibration level
The vibration emission level stated in this instruction
manual has been measured in accordance with a
standardized test given in EN60745; it may be used
to compare one tool with another and as a prelim-
inary assessment of exposure to vibration when
using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
RH504AC
230 V ~
50Hz
1500W
0-860 /min
0-4250 /min
Ø 32 mm
Ø 13 mm
Ø 42 mm
5.2 kg
92.7dB(A) K=3 dB(A)
103.7dB(A) K=3 dB(A)
17.360m/s² K=1.5m/s²
13.334m/s² K=1.5m/s²
WWW.VONROC.COM