Genesis GLSI08B Manual Del Operario página 7

KNOWING YOUr SOLDErING IrON
8
11
1.
On/Off Switch
2.
On/Off LeD Indictor
3.
Fine Point Tip
4.
Battery Locking Tab
UNPACKING AND CONTENT
:
IMPOrTANT
is faulty or that a part is missing. If you find anything wrong, do not operate the tool until
the parts have been replaced or the fault has been rectified. Failure to do so could result
in serious personal injury.
CONTENTS IN PACKAGE
Description
Soldering Iron
Charging Stand
Iron Holder
Solder Wire
Tip Cleaning Sponge
OPErATION
WArNING:
important safety warning and instructions before using this tool.
WArNING:
removal of the battery pack.
INSTALLING OR REMOVING THE BATTERY PACK
(FIG 2)
• To install the battery pack, insert the battery pack (5) from the bottom of the
tool all the way until it locks in place with a click, as shown in FIG 2.
• To remove the battery pack, slide the battery locking tab (4) to the left as
shown in FIG 2, to release the battery pack, then pull the battery pack out.
9
10
12
7
5.
Battery Pack
6.
Solder Wire
7.
Chisel Tip
8.
Charging Adaptor
Due to modern mass production techniques, it is unlikely the product
:
QTY Description
1 Battery Pack (GLAB08B)
1 Charging Adaptor
1 Iron Holder Base
1 Chisel Tip
1 Operator's Manual
To reduce the risk of serious personal injuries, read and follow all
Always be sure that the tool is switched off before insertion or
2
3
6
FIG 1
9.
Charging Stand
10.
Iron Holder Base
11.
Iron Holder
12.
Tip Cleaning Sponge
QTY
1
1
1
1
1
1
4
5
4
5
FIG 2
7