How To Operate - Nostalgia Products Coca-Cola RSM650COKE Serie Instrucciones Y Recetas

HOW TO OPERATE

1. First, find a stable, waterproof surface near an electrical outlet before
starting. Make sure the cord is away from any water source.
2. DO NOT place the COCA-COLA® SERIES SLUSH MACHINE
near the edge of a table or countertop.
3. Remove the Blending Chamber Lid by pinching the lock tab together
while lifting up on the Lid and carefully unhinging the front.
4. Fill the Aluminum Cylinder with small or broken pieces
of ice through opening labeled ICE AND SALT, to within
1 inch of the Aluminum Cylinder top. Ensure that the
Spout is in the closed position to avoid spillage.
5. Add ½ cup of regular table salt and ½ cup of water in the
Aluminum Cylinder (be sure to add salt first then water in
order to mix well). Salt is necessary for the freezing process.
It may take ½ cup of salt or more for your slush to freeze
properly. Return the Lid to Blending Chamber, making
sure it is aligned properly over the mixing mechanism,
locked down securely to the clear mixing chamber, and lid is latched securely.
6. Slide the ON/OFF switch back to FREEZE to turn the unit on and begin the slush making
process. DO NOT turn the unit OFF during use as the Aluminum Cylinder may freeze.
7. Pour your selected beverage directly into the unit through the molded square indention
located on the top of your COCA-COLA® SERIES SLUSH MACHINE.
DO NOT fill beyond the MAX FILL line (approximately 1 qt.
of liquid). Sugar-free beverages and alcoholic beverages
will not freeze. DO NOT use them in the machine.
NOTE: Do not use the slush maker to freeze liquids
without any sugar (such as water), as this may damage the
appliance. Water will freeze very quickly to the exterior
of the ice cylinder and could damage the unit.
8. Allow the mixture to blend for up to 15 minutes
until you reach the desired slush consistency.
NOTE: You can continually add ice and salt to the unit as you are creating slush by
dropping ice and salt into the round, open hole in the Lid above the Aluminum
Cylinder. DO NOT exceed filling the Aluminum Cylinder 1 inch from the top as
there is a risk that the slush mixture will become contaminated with salt.
9. When mixture reaches desired consistency, place cup under
Spout and slide the ON/OFF switch forward to DISPENSE.
Turn the slush dispenser handle to the right to dispense
drink. Keep unit running until all slush has been dispensed.
Be sure to turn handle back to CLOSE after filling each cup.
NOTE: If slush gets too thick, or does not dispense well,
add more liquid to the mixing chamber opening.
6