Toshiba RAV-SM564UTP-E Manual Del Proprietário página 37

Ocultar thumbs Ver también para RAV-SM564UTP-E:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
„ Setting the louver lock
1
UNIT LOUVER
Push and hold the
button (right side of
the button) for at least 4 seconds while
running is stopped.
blinks.
• When no unit number is displayed, all units are
selected.
2
Push the
button (left side of the button)
to select a unit.
The unit number changes each time you push the
button.
Unit No.
Unit No.
Unit No.
1-1
2-1
3-1
Unit No.
4-1
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP.
" buttons to
display the number of the louver to fix its
direction.
The selected louver swings.
4
Push the
buttons to select the
direction of the louver you do not want to
swing.
(1)
(2)
(3)
0001
0002
0003
(4)
(5)
0004
0005
* If (4) or (5) is selected, condensation may occur
during cooling.
5
Push the
button to confirm the setting.
When the setting is confirmed, the
mark lights
up.
(To set the louver lock of another unit, repeat from
Step 2. To set another louver lock of the same unit,
repeat from Step 3.)
6
Push the
button to finish the setting.
71-EN
0001 - 0005
(Louver position
Louver No.
code)
* F1 appears in the CODE No. section on the
remote controller. This indicates that the louver
01 shown in the following figure is selected.
Electrical control box
03
Refrigerant
pipe
04
02
Drain pipe
01
NOTE
Even in louver lock mode, the louver temporarily
moves in the following cases:
• When the air conditioner is stopped
„ „ Releasing the louver lock
Set "0000" in Step 4 of "Setting the louver lock".
The
mark disappears.
* Steps 1 - 3 and 5, 6 of "Setting
the louver lock" also apply to
SET DATA
releasing the lock.
◆ Adjusting the horizontal direction
1
Push and hold the
and "TEMP.
buttons for at least 4 seconds while running
is stopped.
blinks.
"01" appears in CODE No.
2
Push the
button (left side of the button)
to select a unit
The unit number changes each time you push the
button.
Unit No.
Unit No.
Unit No.
1-1
2-1
3-1
No
Unit No.
display
4-1
The fan of the selected unit runs, and the louver
swings.
3
Push the "TEMP.
" buttons to
change the CODE No. to "45".
4
Push the "TIME
"buttons to select a
direction.
Direction SET
Direction setting
DATA
Smudging reduction position
"0000"
(reduces ceiling smudging)
Cold draft position
(Less directly expose your body to
"0002"
cool air)
(factory default)
5
Push the
button to check the settings.
The indicator stops blinking and stays lit, and the
settings are confirmed.
6
Push
button to finish the setting.
* If the cold draft position is selected, the ceiling
smudging reduction effect will be reduced.
– 36 –
0000
"
72-EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Rav-sm804utp-eRav-sm1104utp-eRav-sm1404utp-eRav-sm1604utp-e

Tabla de contenido