Troubleshooting Guide - Desa International JourneyMan Serie Manual De Instrucciones

Troubleshooting Guide

If you have a problem, please follow this guide. You may also want to visit our Web site at: www.desatech.com. For
more help call 1-800-858-8501 8:00 AM to 4:30 PM Central Time weekdays.
Lo sentimos, pero no podemos contestar preguntas en español por teléfono.
SYMPTOM
POSSIBLE CAUSE
1. Light switch is turned off.
Lights will
2. Flood light is loose or burned out.
not come
3. Fuse is blown or circuit breaker is
on.
turned off.
4. Daylight turnoff is in effect. (Re-
check after dark) .
5. Incorrect circuit wiring, if this is a
new installation.
6. Re-aim the sensor to cover de-
sired area.
Lights
1. Control may be installed in a rela-
come on in tively dark location.
daylight. 2. Control is in Test. (Set control
switch to an ON-TIME position) .
Lights come
1. Control may be sensing small ani-
on for no
mals or automobile traffic. ( Re-
apparent
aim sensor or use lens shield) .
reason. 2. Sensitivity is set too high. (Reduce
sensitivity. Turn Range Boost off) .
SYMPTOM POSSIBLE CAUSE
Lights stay on 1. A lamp is positioned too close to the
continuously.
2. Control is pointed at a heat source
Lights flash
1. Heat or light from the lamps may be
on and off.
2. Reflected heat from other objects
3. Control is in warming up. (Flashing is
4. Control is in Test. (Set control switch
-12-
sensor or pointed at objects that
causes the sensor to trigger. (Aim
the lamp away from the sensor or
objects).
like an air vent, dryer vent, or brightly-
painted heat-reflective surface. (Re-
aim sensor. Turn Boost off).
turning the Light Control on and off.
(Aim lamps away from the sensor.
Turn Boost off).
are triggering the sensor. (Re-aim
sensor. Turn Boost off).
normal under these conditions. Wait
1 minute for sensor to warm up).
to an ON-TIME position).
595-5660-05