Chicco Urban Plus Manual Del Usuario página 21

ec- To re-assemble the safety belts systems, follow the se-
ent quence below carefully:
19. Pass the belt through the slot as shown in Fig. 19, mak-
ull ing sure that the length adjuster is positioned as shown in
ed Fig. 19A.
20. Take the plastic slot end of the shoulder straps and intro-
en duce it into the safety belt's fabric ring (Fig. 20).
21. After performing this operation properly, pull the belt
downwards until the fabric ring is turned inside out (Fig.
21A-21B).
22. WARNING: At the end of assembly, make sure that the
ee
plastic slots are properly assembled. Check that the plastic
ne- slots, once assembled on the relative safety harness buckle
ed forks, feature the relative horizontal protruding parts facing
the seat's exterior (fig. 22A-22B).
to At the end of the assembly, the belts must be adjusted
once again according to the size of your child.
CONVERTING THE SEAT: PRAM CONFIGURATION
ns, To transform the seat into a pram, follow the steps below:
23. Unfasten the buckles located under the seat (fig. 23 –
23A).
24. Position the foot rest horizontally, adjust the back rest
in the lowest position (Fig. 24), recline the seat by pressing
the buttons shown in Fig. 11, and bring the pram into the
fig. horizontal position (fig. 24A).
25. Remove the safety belts (see paragraph REMOVE
SAFETY BELTS), making sure to store them away out of
om
the reach of your child.
WARNING: The pram must be used only in horizontal posi-
T a
tion (fig. 25A). Do not adjust the pram when inclined (Fig
ler 25B).
26. To introduce the fabric lining, fasten it to the fabric of
the stroller by using the internal zip (Fig. 26) located in the
child's head area.
ve 27. Then wrap the elastic part of the fabric lining around the
wo tube of the structure in the foot area (Fig. 27). Lastly, fasten
le, the press stud buttons positioned on both sides (Fig. 27A).
WARNING: When the seat is in the pram configuration,
se it should be fitted onto the stroller facing the parent (Fig.
la- 27B-27C).
WARNING: In pram configuration, do not remove the seat
by from the stroller when the child is inside it.
lot
ap
CONVERTING THE SEAT: SEMI-
ng
RIGID CARRY COT CONFIGURA-
tly.
rks
TION
D-
IMPORTANT- KEEP THESE IN-
ety
STRUCTION FOR FUTURE REFER-
ess
ENCE.
WARNING: BEFORE USE, REMOVE
AND DISPOSE OF ALL PLASTIC BAGS
in
AND PACKAGING MATERIALS AND
la-
KEEP THEM OUT OF REACH OF CHIL-
b-
ety
DREN.
rly
WARNINGS
• Please refer to the instructions book-
let before using the stroller.
• WARNING: This product is only
suitable for a child who cannot sit
up unaided, roll over and cannot
push up on its hands and knees.
Maximum weight of the child: 9 Kg.
• Indicative age of use: 0 – 5/6
months.
• WARNING: Only use on a firm, hor-
izontal level and dry surface.
• WARNING: Do not let other chil-
dren play unattended near the car-
rycot.
• WARNING: Do not use if any part
of the carrycot is broken, torn or
missing.
• Only use spare parts supplied or
approved by the manufacturer
• Do not fit to the carrycot any acces-
sories, spare parts or components
not supplied or approved by the
manufacturer. Any unauthorised
modifications made to the product
will relieve the manufacturer from
all responsabilities.
• Always be aware of the risk of open
fire and other source of strong heat,
such as electric bar fires, gas fires,
etc. in the near vicinity of carry cot.
• Periodically check the product's
physical and structural integrity. in
particular, the carrying handle and
the bottom of the carrycot. Should
any damage or signs of wear and
tear be noticeable, do not use the
product and keep out of reach of
children.
• Make sure that the handle is in
the correct position for use before
transport in the carrycot.
• The child's head in the carrycot
must never be kept lower than the
21