Install The Drawers; Glide Adjustment - Gladiator Garageworks 2253694A Instrucciones De Ensamblaje

Install the Drawers

Removing the Drawers
1. Unload the contents from the drawer.
2. Slide the drawer out to its fully open position.
3. Press the lever down on the right-hand track and lift the lever
up on the left track to release the drawer. Continue to pull the
drawer until it comes free.
Replacing the Drawers
1. Align the drawer guides with the receiving glides.
2. Holding the receiving glides firmly in place, insert the drawer
guide.
NOTE: It is normal for the drawer to close tightly the first time
after it has been removed.
3. Push the drawer in completely.
Changing Drawer Location
Follow the steps for glide adjustment before following the steps
for replacing the drawer.
1
1. Lever

Glide Adjustment

(optional)
For drawer flexibility, you can remove the drawer glides and
reinstall them in the desired locations.
Removing the Drawer Glide
1. Back of glide
1. Unload the drawer and remove (see "Install the Drawers").
2. Insert a flat-blade screwdriver behind the first slot between
the glide and cabinet panel.
3. Using the screwdriver, pry the glide away from the cabinet
panel while pushing the glide toward the rear of the cabinet
until the glide comes free.
Replacing the Drawer Glide
1. Determine the desired height for the drawer.
2. Insert the glide tabs into the openings in the cabinet panel.
3. Holding onto the back of the glide, pull it toward you until it
locks in place.
4. Replace the drawer (see "Install the Drawers").
1
5