Care Instructions - Hesperide 165677 Manual De Instrucciones

CARE INSTRUCTIONS

1/ Your product
Properties
Epoxy steel is a steel covered with a protective paint against rust.
Tempered glass is a glass that has endured a thermal treatment. If it breaks it breaks into little non-sharp
pieces.
The surface of the tempered glass is smooth, non-porous and easy to clean.
Resin wicker PE (polyethylene) is a recyclable plastic material (polyethylene.) Its braiding is done by hand.
Polyester is a synthetic fabric that offers good resistance to tearing and rubbing.
Manufacturing and assembly
The manufacturing then assembly of this product requires leaving clearance between the different parts.
It is therefore normal to observe gaps/slack that may reach several millimetres between the different
assembled elements (between two slats, between boards...).
This tolerance necessary for the correct realisation of your product can be behind little geometric differences.
This does not lead to any loss of function of your product.
Irregular appearance
Each product is manufactured and assembled industrially from parts whose surface treatment is carried out
individually, before assembly. These metallic elements cannot be free from appearance irregularities coming
both from the surface treatment process and assembly operations. The final appearance of the product is
therefore directly linked to these possible irregularities.
Regularity of seams
Although we pay special attention to the quality and regularity of seams, it is possible to notice that some
threads are not cut after the break point of the seam. There is no risk of the seam becoming undone. Cut this
thread with a simple pair of scissors.
Regularity of the braiding
This garden furniture is entirely hand braided. The braiding technique consists in an intertwining of synthetic
resin strands around a metallic structure. It is possible to observe braiding tension differences. At each break
point, the end of the strand in addition, ranging up to a few centimetres, is inserted into the braiding. If this
strand comes out, put it back in place. There is no risk of the braiding becoming undone.
Synthetic resin imitates natural rattan. Rattan has appearance irregularities that give it its unique character.
The manufacturing process reproduces these variations in look and shade.
2/ Precautions for use
Do not put hot objects on the table itself, they will leave permanent marks on it (discoloration, deformation,
cracks...). Always use table mats.
Do not use a plastic tablecloth on the table. Exposed to UV and heat, it would melt and act as a decal,
especially on steel, aluminum and glass. This would result in irreparable deterioration of the tray in the form
of white streaks. Instead, use a fabric tablecloth.
Avoid thermal shocks on the glass (do not put hot objects directly on the table, use table mats, do not put icy
products if the table is in direct sunlight). The accumulation of this type of thermal shock makes the glass
fragile and can cause it to explode. However this phenomenon remains rare and presents no danger: the
tempered glass explodes into small non-sharp pieces.
Watch out for blows from knives and other sharp objects handled nearby. Watch out too for burns from
cigarettes and from other heat sources.
If you don't use your cushions for a long period, it is advised to put them away to avoid possible discoloura-
tion during too long an exposure to UV rays.