Fermax HALO & iLOFT Manual página 76

Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft
Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft
Monitor settings
To access configuration mode, press the button
blink once a second and a confirmation tone will be emitted).
On accessing configuration mode, the monitor will go into volume settings mode
Press the button
(2 sec.)
To adjust the different configuration options, while in the required option, follow these
steps:
Set Call Bell Volume
- press the button
- press the button
Call Tone and Call Cancellation (do not disturb mode)
- press the button
contrast configurations it incorporates.
- press the button
The monitor led blinks on red to indicate «do not disturb» mode
To reactivate call functions, press the button
Image Settings (Brightness-Contrast and Colour)
In image configuration mode, the led blinks once every two seconds, indicating that the monitor
is in this mode.
The monitor has 4 pre-established settings with a specific level of brightness and
contrast and 4 colour levels.
On pressing the corresponding button you can select the brightness/contrast level or
colour setting.
When you come to the last option, an error tone is emitted and it returns to the first one.
- press the button
- press the button
Pag 36
All manuals and user guides at all-guides.com
to move through the configuration options in order:
: Volume Settings.
: Tone Selection.
: Image Settings.
to select a high volume or
to select a low volume.
to select the call tone. You will go through all the brightness-
to activate the call cancellation function (do not disturb mode);
to select brightness and contrast.
to configure colour.
down for two seconds (the led will
.
.